I think a homemade cart is best because you can design one that works exactly the way you want it to, in fact, in this forum discussion they talk about how they built homemade carts to prevent items from crashing into their welders, to support multiple welders and to hold useful welding supplies. I like this question a lot, but it comes down to this : personal preference. Use a shorter wire stick out – it will help you as a beginner to run a better bead.It might be different that what the manufacturer suggests on the built in chart. Get a small book and write down what works. Don’t pay attention to the number displayed on wire speed and voltage.Now there is a lot of information in this post, but here are some good take aways that you can use right now: This is a great discussion for someone brand new to welding – how to run a good bead. Pure argon for TIG and C25 for general MIG work.Ī good Argon regulator for your tank would be good. If your just doing TIG work then that would be possible, but for a good fab shop, and someone beginning to weld, then a good recommendation is this : In this discussion a user asked if they can use pure Argon as their only shielding gas. Here is a good plan to build one in your spare time. In fact, you can build one pretty easily yourself. Now, you don’t need something fancy and over the top – a simple sturdy workbench is fine to start you off. With these tools you’ll have the basic setup to professionally line up, tack down your metal – and finished the job.Ī sturdy workbench is important because it is the base for all your projects. Of course you’ll need a welder, but some overlooked tools by the new welder are : c clamps, a wire cutter and an angle grinder. In order to weld properly and professionally you’ll need some basic tools to get the job done correctly. You’ll have some dedicated space to position your materials and leave your work for a short time without it being disturbed. A garage (make sure it’s well ventilated) would be a good space to start off in. You want to make sure you have a good work space dedicated to welding – it’s no fun trying to weld and tripping over morris the cat. If fact, here is a good beginners MIG welder I wrote a review on, check it out. That way you develop a “feel” for the distance, rhythm and speed at which you should move. Get the feel, the distance and the motion down before you actually lay a weld. Throw on your hood and your safety gear, Grab your MIG gun and start to weld, without welding. Ok, I know this sounds like common sense, but let me explain. Here and some tips and tricks to get you welding fast, even if you don’t know an angle grinder from a clamp. Let’s say your 100% new to welding and you have no idea where to begin. I’ve listed the best tips tricks and habits right below. The key to good welding is to learn the right habits and techniques. Most welders learn the wrong way, and form bad habits. I chose the best welding tips and tricks so you could spend time practicing MIG, TIG or stick welding the right way. As I read through the notes I asked myself, “what are my best tips for welding that I could to someone starting to weld?” I blew off the dust and found my old welding notebook. “Welding tips and tricks” was scribbled across the front of my notebooks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |